Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:TRANsition:SOURce

1070 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
33 :TRIGger Commands
:TRIGger:TRANsition:SOURce
(see page 1276)
Command Syntax
:TRIGger:TRANsition:SOURce <source>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :TRIGger:TRANsition:SOURce command selects the channel used to produce
the trigger.
Query Syntax
:TRIGger:TRANsition:SOURce?
The :TRIGger:TRANsition:SOURce? query returns the current transition trigger
source.
Return Format
<source><NL>
<source> ::= CHAN<n>
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:MODE" on page 1016
• ":TRIGger:TRANsition:SLOPe" on page 1069