732 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:CAN:SIGNal:DEFinition
(see page 1276)
Command Syntax
:SBUS<n>:CAN:SIGNal:DEFinition <value>
<value> ::= {CANH | CANL | RX | TX | DIFFerential | DIFL | DIFH}
The :SBUS<n>:CAN:SIGNal:DEFinition command sets the CAN signal type when
:SBUS<n>:CAN:TRIGger is set to SOF (start of frame). These signals can be set to:
Dominant high signals:
• CANH — the actual CAN_H differential bus signal.
• DIFH — the CAN differential (H-L) bus signal connected to an analog source
channel using a differential probe.
Dominant low signals:
• CANL — the actual CAN_L differential bus signal.
• RX — the Receive signal from the CAN bus transceiver.
• TX — the Transmit signal to the CAN bus transceiver.
• DIFL — the CAN differential (L-H) bus signal connected to an analog source
channel using a differential probe.
• DIFFerential — the CAN differential bus signal connected to an analog source
channel using a differential probe. This is the same as DIFL.
Query Syntax
:SBUS<n>:CAN:SIGNal:DEFinition?
The :SBUS<n>:CAN:SIGNal:DEFinition? query returns the current CAN signal type.
Return Format
<value><NL>
<value> ::= {CANH | CANL | RX | TX | DIFL | DIFH}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":SBUS<n>:MODE" on page 701
• ":SBUS<n>:CAN:SIGNal:BAUDrate" on page 731
• ":SBUS<n>:CAN:SOURce" on page 734
• ":SBUS<n>:CAN:TRIGger" on page 735
To Next Page
Loading...
