Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

1086 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

33 :TRIGger Commands

:TRIGger:ZONE<n>:PLACement

(see page 1276)

Command Syntax

:TRIGger:ZONE<n>:PLACement <width>, <height>, <x_center>, <y_center>

<width> ::= width of zone in seconds

<height> ::= height of zone in volts

<x_center> ::= center of zone in seconds

<y_center> ::= center of zone in volts

<n> ::= 1-2 in NR1 format

The :TRIGger:ZONE<n>:PLACement command sets the size and location of Zone 1

or Zone 2.

No error is returned if the zone is placed off-screen, or if the zones overlap such

that Zone 2 becomes invalid. The :TRIGger:ZONE<n>:VALidity? query is used to

retrieve this information.

Query Syntax

:TRIGger:ZONE<n>:PLACement?

The :TRIGger:ZONE<n>:PLACement? query returns the size and location of Zone 1

or Zone 2.

Return Format

See Also • ":TRIGger:ZONE<n>:STATe" on page 1088

• ":TRIGger:ZONE<n>:MODE" on page 1085

• ":TRIGger:ZONE<n>:VALidity" on page 1087

Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:ZONE<n>:PLACement