1136 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
35 :WGEN<w> Commands
:WGEN<w>:FREQuency
(see page 1276)
Command Syntax
:WGEN<w>:FREQuency <frequency>
<w> ::= 1 or 2 in NR1 format
<frequency> ::= frequency in Hz in NR3 format
For all waveforms except Noise and DC, the :WGEN<w>:FREQuency command
specifies the frequency of the waveform.
You can also specify the frequency indirectly using the :WGEN<w>:PERiod
command.
Query Syntax
:WGEN<w>:FREQuency?
The :WGEN<w>:FREQuency? query returns the currently set waveform generator
frequency.
Return Format
<frequency><NL>
<frequency> ::= frequency in Hz in NR3 format
See Also • "Introduction to :WGEN<w> Commands" on page 1128
• ":WGEN<w>:FUNCtion" on page 1137
• ":WGEN<w>:PERiod" on page 1159
To Next Page
Loading...
