Keysight Technologies InfiniiVision 3000T X Series - :WAVeform:TYPE

1116 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
34 :WAVeform Commands
:WAVeform:TYPE
(see page 1276)
Query Syntax
:WAVeform:TYPE?
The :WAVeform:TYPE? query returns the acquisition mode associated with the
currently selected waveform. The acquisition mode is set by the :ACQuire:TYPE
command.
Return Format
<mode><NL>
<mode> ::= {NORM | PEAK | AVER | HRES}
See Also • "Introduction to :WAVeform Commands" on page 1091
• ":ACQuire:TYPE" on page 243
• ":WAVeform:DATA" on page 1099
• ":WAVeform:PREamble" on page 1106
• ":WAVeform:SOURce" on page 1111
NOTE
If the :WAVeform:SOURce is POD1, POD2, or SBUS1, SBUS2, the type is always NORM.