Keysight Technologies InfiniiVision 3000T X Series User Manual

Common (*) Commands 5
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 169
*CLS (Clear Status)
(see page 1276)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the device-defined
error queue, and the Request-for-OPC flag.
See Also • "Introduction to Common (*) Commands" on page 168
• "*STB (Read Status Byte)" on page 186
• "*ESE (Standard Event Status Enable)" on page 170
• "*ESR (Standard Event Status Register)" on page 172
• "*SRE (Service Request Enable)" on page 184
• ":SYSTem:ERRor" on page 983
NOTE
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English