704 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:A429:AUTosetup
(see page 1276)
Command Syntax
:SBUS<n>:A429:AUTosetup
The :SBUS<n>:A429:AUTosetup command automatically sets these options for
decoding and triggering on ARINC 429 signals:
• High Trigger Threshold: 3.0 V.
• Low Trigger Threshold: -3.0 V.
• Noise Reject: Off.
• Probe Attenuation: 10.0.
•Vertical Scale: 4V/div.
•Serial Decode: On.
• Base (:SBUS<n>:A429:BASE): HEX.
• Word Format (:SBUS<n>:A429:FORMat): LDSDi (Label/SDI/Data/SSM).
• Trigger: the specified serial bus (n of SBUS<n>).
• Trigger Mode (:SBUS<n>:A429:TRIGger:TYPE): WSTArt.
Errors • "-241, Hardware missing" on page 1235
See Also • ":SBUS<n>:A429:BASE" on page 705
• ":SBUS<n>:A429:FORMat" on page 709
• ":SBUS<n>:A429:TRIGger:TYPE" on page 718
• "Introduction to :SBUS<n> Commands" on page 697
• ":SBUS<n>:MODE" on page 701
• ":SBUS<n>:A429 Commands" on page 702
To Next Page
Loading...
