Keysight Technologies InfiniiVision 3000T X Series - :COUNter:TOTalize:GATE:ENABle

:COUNter Commands 11
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 295
:COUNter:TOTalize:GATE:ENABle
(see page 1276)
Command Syntax
:COUNter:TOTalize:GATE:ENABle {{0 | OFF} | {1 | ON}}
The :COUNter:TOTalize:GATE:ENABle command enables or disables totalizer
gating.
When totalizer gating is enabled, the totalizer only counts edges when a second
gating signal polarity is true. The second gating signal can be one of the remaining
analog channel inputs.
Query Syntax
:COUNter:TOTalize:GATE:ENABle?
The :COUNter:TOTalize:GATE:ENABle? query returns whether totalizer gating is
enabled or disabled.
Return Format
<off_on><NL>
{0 | 1}
See Also • ":COUNter:CURRent" on page 289
• ":COUNter:ENABle" on page 290
• ":COUNter:MODE" on page 291
• ":COUNter:NDIGits" on page 292
• ":COUNter:SOURce" on page 293
• ":COUNter:TOTalize:CLEar" on page 294
• ":COUNter:TOTalize:GATE:POLarity" on page 296
• ":COUNter:TOTalize:GATE:SOURce" on page 297
• ":COUNter:TOTalize:SLOPe" on page 298