Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

:POWer Commands 26

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 647

:POWer:SWITch:IREFerence

(see page 1276)

Command Syntax

:POWer:SWITch:IREFerence <percent>

<percent> ::= percent in NR1 format

The :POWer:SWITch:IREFerence command to specify the current switching level

for the start of switching edges. The value is in percentage of the maximum switch

current.

You can adjust this value to ignore noise floors or null offset that is difficult to

eliminate in current probes.

This value specifies the threshold that is used to determine the switching edges.

Query Syntax

:POWer:SWITch:IREFerence?

The :POWer:SWITch:IREFerence query returns the current switching level percent

value.

Return Format

<percent> ::= percent in NR1 format

See Also • ":POWer:SWITch:APPLy" on page 645

• ":POWer:SWITch:CONDuction" on page 646

• ":POWer:SWITch:RDS" on page 648

• ":POWer:SWITch:VCE" on page 649

• ":POWer:SWITch:VREFerence" on page 650

Keysight Technologies InfiniiVision 3000T X Series - :POWer:SWITch:IREFerence