Keysight Technologies InfiniiVision 3000T X Series User Manual

292 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
11 :COUNter Commands
:COUNter:NDIGits
(see page 1276)
Command Syntax
:COUNter:NDIGits <value>
<value> ::= 3 to 8 in NR1 format
The :COUNter:NDIGits command sets the number of digits of resolution used for
the frequency or period counter.
Higher resolutions require longer gate times, which cause the measurement times
to be longer as well.
Query Syntax
:COUNter:NDIGits
The :COUNter:NDIGits? query returns the currently set number of digits of
resolution.
Return Format
<value><NL>
<value> ::= 3 to 8 in NR1 format
See Also • ":COUNter:CURRent" on page 289
• ":COUNter:ENABle" on page 290
• ":COUNter:MODE" on page 291
• ":COUNter:SOURce" on page 293
• ":COUNter:TOTalize:CLEar" on page 294
• ":COUNter:TOTalize:GATE:ENABle" on page 295
• ":COUNter:TOTalize:GATE:POLarity" on page 296
• ":COUNter:TOTalize:GATE:SOURce" on page 297
• ":COUNter:TOTalize:SLOPe" on page 298

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English