Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:CAN:COUNt:RESet

724 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:CAN:COUNt:RESet
(see page 1276)
Command Syntax
:SBUS<n>:CAN:COUNt:RESet
Resets the frame counters.
Errors • "-241, Hardware missing" on page 1235
See Also • ":SBUS<n>:CAN:COUNt:ERRor" on page 722
• ":SBUS<n>:CAN:COUNt:OVERload" on page 723
• ":SBUS<n>:CAN:COUNt:TOTal" on page 726
• ":SBUS<n>:CAN:COUNt:UTILization" on page 727
• "Introduction to :SBUS<n> Commands" on page 697
• ":SBUS<n>:MODE" on page 701
• ":SBUS<n>:CAN Commands" on page 719