:MEASure Commands 22
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 505
:MEASure:STATistics:RESet
(see page 1276)
Command Syntax
:MEASure:STATistics:RESet
This command resets the measurement statistics, zeroing the counts.
Note that the measurement (statistics) configuration is not deleted.
See Also • "Introduction to :MEASure Commands" on page 458
• ":MEASure:STATistics" on page 501
• ":MEASure:STATistics:DISPlay" on page 502
• ":MEASure:RESults" on page 493
• ":MEASure:STATistics:INCRement" on page 503
Example Code • "Example Code" on page 493