Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:UART:COUNt:RESet

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 873
:SBUS<n>:UART:COUNt:RESet
(see page 1276)
Command Syntax
:SBUS<n>:UART:COUNt:RESet
Resets the UART frame counters.
Errors • "-241, Hardware missing" on page 1235
See Also • ":SBUS<n>:UART:COUNt:ERRor" on page 872
• ":SBUS<n>:UART:COUNt:RXFRames" on page 874
• ":SBUS<n>:UART:COUNt:TXFRames" on page 875
• "Introduction to :SBUS<n> Commands" on page 697
• ":SBUS<n>:MODE" on page 701
• ":SBUS<n>:UART Commands" on page 866