Keysight Technologies InfiniiVision 3000T X Series - :POWer:SIGNals:VMAXimum:ONOFf:ON

:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 637
:POWer:SIGNals:VMAXimum:ONOFf:ON
(see page 1276)
Command Syntax
:POWer:SIGNals:VMAXimum:ONOFf:ON <value>[suffix]
<value> ::= Maximum expected input Voltage in NR3 format
[suffix] ::= {V | mV}
The :POWer:SIGNals:VMAXimum:ONOFf:ON command specifies the maximum
expected input voltage. This value is used to set the vertical scale of the channel
probing voltage for turn on analysis.
Query Syntax
:POWer:SIGNals:VMAXimum:ONOFf:ON?
The :POWer:SIGNals:VMAXimum:ONOFf:ON query returns the expected maximum
input voltage setting.
Return Format
<value><NL>
<value> ::= Maximum expected input Voltage in NR3 format
See Also • ":POWer:ONOFf:APPLy" on page 614
• ":POWer:SIGNals:AUTosetup" on page 624
• ":POWer:SIGNals:DURation:ONOFf:ON" on page 630
• ":POWer:SIGNals:IEXPected" on page 633
• ":POWer:SIGNals:OVERshoot" on page 634
• ":POWer:SIGNals:VSTeady:ONOFf:ON" on page 639
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 641
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 642