Keysight Technologies InfiniiVision 3000T X Series - :SEARch:SERial:I2 S:PATTern:DATA

:SEARch Commands 30
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 945
:SEARch:SERial:I2S:PATTern:DATA
(see page 1276)
Command Syntax
:SEARch:SERial:I2S:PATTern:DATA <string>
<string> ::= "n" where n ::= 32-bit integer in signed decimal
when <base> = DECimal
<string> ::= "nn...n" where n ::= {0 |1|X}when <base> = BINary
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X}
when <base> = HEX
The :SEARch:SERial:I2S:PATTern:DATA command specifies the data word value
when searching for I2S events.
The base of the value entered with this command is specified using the
:SEARch:SERial:I2S:PATTern:FORMat command.
Query Syntax
:SEARch:SERial:I2S:PATTern:DATA?
The :SEARch:SERial:I2S:PATTern:DATA? query returns the current data word value
setting.
Return Format
<string><NL>
<string> ::= "n" where n ::= 32-bit integer in signed decimal
when <base> = DECimal
<string> ::= "nn...n" where n ::= {0 |1|X}when <base> = BINary
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X}
when <base> = HEX
See Also • Chapter 30, “:SEARch Commands,” starting on page 889
• ":SEARch:SERial:I2S:MODE" on page 944
• ":SEARch:SERial:I2S:PATTern:FORMat" on page 946