328 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
14 :DISPlay Commands
:DISPlay:LABList
(see page 1276)
Command Syntax
:DISPlay:LABList <binary block data>
<binary block> ::= an ordered list of up to 75 labels, a maximum of 10
characters each, separated by newline characters.
The :DISPlay:LABList command adds labels to the label list. Labels are added in
alphabetical order.
Query Syntax
:DISPlay:LABList?
The :DISPlay:LABList? query returns the label list.
Return Format
<binary block><NL>
<binary block> ::= an ordered list of up to 75 labels, a maximum of 10
characters each, separated by newline characters.
See Also • "Introduction to :DISPlay Commands" on page 316
• ":DISPlay:LABel" on page 327
• ":CHANnel<n>:LABel" on page 273
• ":DIGital<d>:LABel" on page 310
• ":BUS<n>:LABel" on page 252
Labels that begin with the same alphabetic base string followed by decimal digits are
considered duplicate labels. Duplicate labels are not added to the label list. For example, if
label "A0" is in the list and you try to add a new label called "A123456789", the new label is
not added.
To Next Page
Loading...
