Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:TV:MODE

1074 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
33 :TRIGger Commands
:TRIGger:TV:MODE
(see page 1276)
Command Syntax
:TRIGger:TV:MODE <mode>
<mode> ::= {FIEld1 | FIEld2 | AFIelds | ALINes | LINE | LFIeld1
| LFIeld2 | LALTernate}
The :TRIGger:TV:MODE command selects the TV trigger mode and field. The
LALTernate parameter is not available when :TRIGger:TV:STANdard is GENeric.
Old forms for <mode> are accepted:
Query Syntax
:TRIGger:TV:MODE?
The :TRIGger:TV:MODE? query returns the TV trigger mode.
Return Format
<value><NL>
<value> ::= {FIE1 | FIE2 | AFI | ALIN | LINE | LFI1 | LFI2 | LALT}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:TV:STANdard" on page 1077
• ":TRIGger:MODE" on page 1016
<mode> Old Forms Accepted
FIEld1 F1
FIEld2 F2
AFIelds ALLFields, ALLFLDS
ALINes ALLLines
LFIeld1 LINEF1, LINEFIELD1
LFIeld2 LINEF2, LINEFIELD2
LALTernate LINEAlt