Keysight Technologies InfiniiVision 3000T X Series - :DEMO:OUTPut

:DEMO Commands 12
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 305
:DEMO:OUTPut
(see page 1276)
Command Syntax
:DEMO:OUTPut <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}
The :DEMO:OUTPut command specifies whether the demo signal output is ON (1)
or OFF (0).
Query Syntax
:DEMO:OUTPut?
The :DEMO:OUTPut? query returns the current state of the demo signal output
setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :DEMO Commands" on page 299
• ":DEMO:FUNCtion" on page 300