Keysight Technologies InfiniiVision 3000T X Series - :MEASure:SHOW

498 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
22 :MEASure Commands
:MEASure:SHOW
(see page 1276)
Command Syntax
:MEASure:SHOW <on_off>
<on_off> ::= {{0 | OFF} | {1 | ON}}
The :MEASure:SHOW command enables markers for tracking measurements on
the display.
Query Syntax
:MEASure:SHOW?
The :MEASure:SHOW? query returns the current state of the markers.
This can return OFF when :MARKer:MODE selects a mode other than
MEASurement.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :MEASure Commands" on page 458
• ":MARKer:MODE" on page 429