Keysight Technologies InfiniiVision 3000T X Series - *RCL (Recall)

Common (*) Commands 5
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 179
*RCL (Recall)
(see page 1276)
Command Syntax
*RCL <value>
<value> ::= {0|1|2|3|4|5|6|7|8|9}
The *RCL command restores the state of the instrument from the specified
save/recall register.
See Also • "Introduction to Common (*) Commands" on page 168
• "*SAV (Save)" on page 183