Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

1214 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

37 Obsolete and Discontinued Commands

:MEASure:VSTOp

(see page 1276)

Command Syntax

:MEASure:VSTOp <vstop_argument>

<vstop_argument> ::= value for Y2 cursor

The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to the

specified value corresponding to the selected source. The source can be selected

by the MARKer:X2Y2source command.

Query Syntax

:MEASure:VSTOp?

The :MEASure:VSTOp? query returns the current value of the Y2 cursor.

Return Format

<value> ::= value of the Y2 cursor in NR3 format

See Also • "Introduction to :MARKer Commands" on page 426

• "Introduction to :MEASure Commands" on page 458

• ":MARKer:Y1Position" on page 437

• ":MARKer:Y2Position" on page 438

• ":MARKer:YDELta" on page 439

• ":MARKer:X2Y2source" on page 433

• ":MEASure:SOURce" on page 499

• ":MEASure:TDELta" on page 1204

• ":MEASure:TSTArt" on page 1208

NOTE

The short form of this command, VSTO, does not follow the defined Long Form to Short Form

Truncation Rules (see page 1278). The normal short form, VST, would be the same for both

VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.

NOTE

The :MEASure:VSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:Y2Position command (see page 438) instead.

Keysight Technologies InfiniiVision 3000T X Series - :MEASure:VSTOp