Keysight Technologies InfiniiVision 3000T X Series - Page 288

288 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
11 :COUNter Commands
Introduction to
:COUNter
Commands
The :COUNter subsystem provides commands to control the counter feature.
Reporting the Setup
Use :COUNter? to query setup information for the COUNter subsystem.
Return Format
The following is a sample response from the :COUNter? query. In this case, the
query was issued following the *RST command.
:COUN:ENAB 0;SOUR CHAN1;MODE FREQ;NDIG 5
:COUNter:TOTalize:GAT
E:SOURce <source>
(see page 297)
:COUNter:TOTalize:GAT
E:SOURce? (see
page 297)
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels)
in NR1 format
:COUNter:TOTalize:SLO
Pe <slope> (see
page 298)
:COUNter:TOTalize:SLO
Pe? (see page 298)
<slope> ::= {{NEGative | FALLing}
| {POSitive | RISing}}
Table 89 :COUNter Commands Summary (continued)
Command Query Options and Query Returns