:FUNCtion<m> Commands 18
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 369
The math function operator, transform, filter, or visualization is selected using the
:FUNCtion<m>:OPERation command. Depending on the selected operation, there
may be other commands for specifying options for that operation. See
":FUNCtion<m>:OPERation" on page 390.
The SOURce1, DISPlay, RANGe, and OFFSet (or REFerence) commands apply to
any function.
Reporting the Setup
Use :FUNCtion<m>? to query setup information for the FUNCtion subsystem.
Return Format
The following is a sample response from the :FUNCtion1? query. In this case, the
query was issued following a *RST command.
:FUNC1:OPER ADD;DISP 0;SOUR1 CHAN1;SOUR2 CHAN2;RANG +8.00E+00;OFFS
+0.0E+00
To Next Page
Loading...
