To Next Page

To Previous Page

:MEASure Commands 22

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 469

Return Format for <meas_spec> = DELay:

{ <edge_spec1> | <edge_spec2> | <edge_spec1>,<edge_spec2>} <NL>

for <meas_spec> = THResholds and <threshold mode> = PERCent:

THR,PERC,<upper>,<middle>,<lower><NL>

<upper>, <middle>, <lower> ::= A number specifying the upper, middle,

and lower threshold percentage values

between Vbase and Vtop in NR3 format.

for <meas_spec> = THResholds and <threshold mode> = ABSolute:

THR,ABS,<upper>,<middle>,<lower><NL>

<upper>, <middle>, <lower> ::= A number specifying the upper, middle,

and lower threshold voltages in NR3

format.

for <threshold spec> = STANdard:

THR,PERC,+90.0,+50.0,+10.0

See Also • "Introduction to :MEASure Commands" on page 458

• ":MEASure:DELay" on page 470

• ":MEASure:SOURce" on page 499

• ":CHANnel<n>:RANGe" on page 282

• ":CHANnel<n>:SCALe" on page 283

• ":CHANnel<n>:PROBe" on page 275

• ":CHANnel<n>:UNITs" on page 284

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: