Keysight Technologies InfiniiVision 3000T X Series - Page 736

736 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
CAN Id specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:ID
and:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE commands.
CAN Data specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:DATA
command.
CAN Data Length Code is set by the
:SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth command.
Query Syntax
:SBUS<n>:CAN:TRIGger?
The :SBUS<n>:CAN:TRIGger? query returns the current CAN trigger on condition.
Return Format
<condition><NL>
<condition> ::= {SOF | EOF | IDD | DATA | FDD | IDR | IDE | ERR | ACK
| FORM | STUF | CRC | SPEC | ALL | BRSB | CRCD | EBA | EBP | OVER
| MESS | MSIG | FDMS}
Errors • "-241, Hardware missing" on page 1235
See Also • "Introduction to :SBUS<n> Commands" on page 697
• ":SBUS<n>:MODE" on page 701
• ":SBUS<n>:CAN:TRIGger:PATTern:DATA" on page 739
• ":SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth" on page 741
SPECerror Spec Error (Ack or Form
or Stuff or CRC)
Triggers on Ack, Form, Stuff, or CRC errors. X
ALLerrors All Errors Triggers on all Spec errors and error frames. X
BRSBit BRS Bit (FD) Triggers on the BRS bit of CAN FD frames. X
CRCDbit CRC Delimiter Bit (FD) Triggers on the CRC delimiter bit in CAN FD
frames.
X
EBActive ESI Bit Active (FD) Triggers on the ESI bit if set active. X
EBPassive ESI Bit Passive (FD) Triggers on the ESI bit if set passive. X
OVERload Overload Frame Triggers on an overload frame.
MESSage Message Triggers on a symbolic message.
MSIGnal Message and Signal
(non-FD)
Triggers on a symbolic message and a
signal value.
FDMSignal Message and Signal (FD,
first 8 bytes only)
Triggers on a symbolic message and a
signal value, limited to the first 8 bytes of
FD data.
* Filtering by CAN IDs is available for these trigger conditions (see :SBUS<n>:CAN:TRIGger:IDFilter).
Condition Front-panel name Description Filter by
ID*