Keysight Technologies InfiniiVision 3000T X Series - Page 9

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 9
:AUToscale:CHANnels / 200
:AUToscale:FDEBug / 201
:BLANk / 202
:DIGitize / 203
:HWEenable (Hardware Event Enable Register) / 205
:HWERegister:CONDition (Hardware Event Condition Register) / 207
:HWERegister[:EVENt] (Hardware Event Event Register) / 208
:MTEenable (Mask Test Event Enable Register) / 209
:MTERegister[:EVENt] (Mask Test Event Event Register) / 211
:OPEE (Operation Status Enable Register) / 213
:OPERegister:CONDition (Operation Status Condition Register) / 215
:OPERegister[:EVENt] (Operation Status Event Register) / 217
:OVLenable (Overload Event Enable Register) / 219
:OVLRegister (Overload Event Register) / 221
:PRINt / 223
:RUN / 224
:SERial / 225
:SINGle / 226
:STATus / 227
:STOP / 228
:TER (Trigger Event Register) / 229
:VIEW / 230
7 :ACQuire Commands
:ACQuire:COMPlete / 233
:ACQuire:COUNt / 234
:ACQuire:MODE / 235
:ACQuire:POINts / 236
:ACQuire:SEGMented:ANALyze / 237
:ACQuire:SEGMented:COUNt / 238
:ACQuire:SEGMented:INDex / 239
:ACQuire:SRATe / 242
:ACQuire:TYPE / 243
8 :BUS<n> Commands
:BUS<n>:BIT<m> / 247
:BUS<n>:BITS / 248
:BUS<n>:CLEar / 250
:BUS<n>:DISPlay / 251
:BUS<n>:LABel / 252
:BUS<n>:MASK / 253