Keysight Technologies InfiniiVision 3000T X Series - Page 980

980 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
31 :SYSTem Commands
Introduction to
:SYSTem
Commands
SYSTem subsystem commands enable writing messages to the display, setting
and reading both the time and the date, querying for errors, and saving and
recalling setups.
:SYSTem:PROTection:LO
CK <value> (see
page 990)
:SYSTem:PROTection:LO
CK? (see page 990)
<value> ::= {{1 | ON} | {0 |
OFF}}
:SYSTem:SETup
<setup_data> (see
page 991)
:SYSTem:SETup? (see
page 991)
<setup_data> ::= data in IEEE
488.2 # format.
:SYSTem:TIME <time>
(see page 993)
:SYSTem:TIME? (see
page 993)
<time> ::= hours,minutes,seconds
in NR1 format
:SYSTem:TOUCh {{1 |
ON} | {0 | OFF}} (see
page 994)
:SYSTem:TOUCh? (see
page 994)
{1 | 0}
Table 134 :SYSTem Commands Summary (continued)
Command Query Options and Query Returns