Keysight Technologies InfiniiVision 3000T X Series - Page 1179

Obsolete and Discontinued Commands 37
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1179
Discontinued
Commands
Discontinued commands are commands that were used by previous oscilloscopes,
but are not supported by the InfiniiVision 3000T X-Series oscilloscopes. Listed
below are the Discontinued commands and the nearest equivalent command
available (if any).
Discontinued Command Current Command Equivalent Comments
ASTore :DISPlay:PERSistence INFinite
(see page 331)
CHANnel:MATH :FUNCtion:OPERation (see
page 390)
ADD not included
CHANnel<n>:PROTect :CHANnel<n>:PROTection (see
page 281)
Previous form of this command
was used to enable/disable
50Ω protection. The new
command resets a tripped
protect and the query returns
the status of TRIPed or
NORMal.
DISPlay:INVerse none
DISPlay:COLumn none
DISPlay:FREeze none
DISPlay:GRID none
DISPLay:LINE none
DISPlay:PIXel none
DISPlay:POSition none
DISPlay:ROW none
DISPlay:TEXT none
FUNCtion:MOVE none
FUNCtion:PEAKs none
HARDcopy:ADDRess none Only parallel printer port is
supported. GPIB printing not
supported
MASK none All commands discontinued,
feature not available
:POWer:SIGNals:CYCLes :POWer:SIGNals:CYCLes:HARM
onics (see page 625)
:POWer:SIGNals:CYCLes:QUALi
ty (see page 626)
This command was separated
into several other commands
for specific types of power
analysis.