1180 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
37 Obsolete and Discontinued Commands
:POWer:SIGNals:DURation :POWer:SIGNals:DURation:EFFi
ciency (see page 627)
:POWer:SIGNals:DURation:MO
Dulation (see page 628)
:POWer:SIGNals:DURation:ON
OFf:OFF (see page 629)
:POWer:SIGNals:DURation:ON
OFf:ON (see page 630)
:POWer:SIGNals:DURation:RIP
Ple (see page 631)
:POWer:SIGNals:DURation:TRA
Nsient (see page 632)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VMAXimum :POWer:SIGNals:VMAXimum:IN
Rush (see page 635)
:POWer:SIGNals:VMAXimum:O
NOFf:OFF (see page 636)
:POWer:SIGNals:VMAXimum:O
NOFf:ON (see page 637)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VSTeady :POWer:SIGNals:VSTeady:ONO
Ff:OFF (see page 638)
:POWer:SIGNals:VSTeady:ONO
Ff:ON (see page 639)
:POWer:SIGNals:VSTeady:TRA
Nsient (see page 640)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SLEW:VALue none Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.
:PWRenable none The Power Event Enable
Register does not exist in the
3000T X-Series oscilloscopes.
:PWRRegister[:EVENt] none The Power Event Event
Register does not exist in the
3000T X-Series oscilloscopes.
SYSTem:KEY none
TEST:ALL *TST (Self Test) (see
page 189)
TRACE subsystem none All commands discontinued,
feature not available
TRIGger:ADVanced subsystem Use new GLITch, PATTern, or TV
trigger modes
Discontinued Command Current Command Equivalent Comments
To Next Page
Loading...
