Keysight Technologies InfiniiVision 3000T X Series - Page 1181

Obsolete and Discontinued Commands 37
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1181
Discontinued
Parameters
Some previous oscilloscope queries returned control setting values of OFF and ON.
The InfiniiVision 3000T X-Series oscilloscopes only return the enumerated values 0
(for off) and 1 (for on).
TRIGger:TV:FIELd :TRIGger:TV:MODE (see
page 1074)
TRIGger:TV:TVHFrej
TRIGger:TV:VIR none
:TRIGger:USB:SOURce:DMINus none USB serial decode and
triggering is not supported on
the 3000T X-Series
oscilloscopes.
:TRIGger:USB:SOURce:DPLus none
:TRIGger:USB:SPEed none
:TRIGger:USB:TRIGger none
VAUToscale none
Discontinued Command Current Command Equivalent Comments