36 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
1 What's New
:FUNCtion<m>:FFT:FREQuency:
STARt (see page 379)
Lets you set the displayed frequency range using start and stop
frequency values.
:FUNCtion<m>:FFT:FREQuency:
STOP (see page 380)
:FUNCtion<m>:SMOoth:POINts
(see page 397)
Sets the number of smoothing points for the new SMOoth
:FUNCtion<m>:OPERation.
:MEASure:BRATe (see
page 462)
Installs a bit rate measurement on screen or returns the measured
value.
:MEASure:RDSon (see
page 542)
Installs an RDS(on) power measurement on screen or returns the
measured value.
:MEASure:VCESat (see
page 547)
Installs a VCE(sat) power measurement on screen or returns the
measured value.
:POWer:EFFiciency:TYPE (see
page 596)
Specifies the type of power that is being converted from the input
to the output.
:SAVE:RESults:[STARt] (see
page 683)
Saves analysis results to a comma-separated values (*.csv) file on
a USB storage device.
:SAVE:RESults:FORMat:CURSo
r (see page 684)
Specifies whether cursor values will be included when analysis
results are saved.
:SAVE:RESults:FORMat:MASK
(see page 685)
Specifies whether mask statistics will be included when analysis
results are saved.
:SAVE:RESults:FORMat:MEASu
rement (see page 686)
Specifies whether measurement results will be included when
analysis results are saved.
:SAVE:RESults:FORMat:SEARc
h (see page 687)
Specifies whether found search event times will be included when
analysis results are saved.
:SAVE:RESults:FORMat:SEGMe
nted (see page 688)
Specifies whether segmented memory acquisition times will be
included when analysis results are saved.
:SEARch:PEAK Commands (see
page 905)
Commands to set up searching for FFT peaks.
:SBUS<n>:CAN:COUNt:SPEC
(see page 725)
Returns the count for the number of Spec errors (Ack + Form +
Stuff + CRC errors).
:SBUS<n>:CAN:FDSPoint (see
page 729)
Sets the CAN FD sample point.
:SBUS<n>:CAN:SIGNal:FDBaud
rate (see page 733)
Sets the CAN FD baud rate.
:SBUS<n>:CAN:TRIGger:IDFilte
r (see page 738)
Specifies, in certain error and bit trgger modes, whether triggers
are filtered by CAN IDs.
:SBUS<n>:CAN:TRIGger:PATTer
n:DATA:DLC (see page 740)
Specifies the DLC value to be used in the CAN FD data trigger
mode.
Command Description
To Next Page
Loading...
