Keysight Technologies InfiniiVision 3000T X Series User Manual

38 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
1 What's New
Discontinued
Commands
:SBUS<n>:CAN:TRIGger (see
page 735)
Has additional parameters that support CAN FD triggering.
:SBUS<n>:MODE (see
page 701)
The SENT mode is now available with the DSOX3SENSOR SENT
serial decode and triggering license.
:SEARch:MODE (see
page 893)
The PEAK option has been added to enable searching for FFT
peaks (see “:SEARch:PEAK Commands" on page 905).
:SEARch:SERial:CAN:MODE
(see page 927)
Has additional parameters that support CAN FD searching.
:WAVeform:SOURce:SUBSourc
e (see page 1115)
You can use FAST (alias for SUB0) to get SENT fast channel data
or SLOW (alias for SBUS1) to get SENT slow channel data.
Command Differences From InfiniiVision 4000 X-Series Oscilloscopes
Discontinued Command Current Command Equivalent Comments
:ACQuire:RSIGnal none There is no 10 MHz REF
connector on the
3000T X-Series oscilloscopes.
:COMPliance Commands none USB signal quality analysis is
not supported on the
3000T X-Series oscilloscopes.
:DVM:FREQuency? :COUNter:CURRent? (see
page 289)
The :DVM:FREQuency? query
has been replaced by the new
Chapter 11, “:COUNter
Commands,” starting on page
287.
:SAVE:COMPliance:USB[:STARt
]
none USB signal quality analysis is
not supported on the
3000T X-Series oscilloscopes.
:SBUS<n>:USB Commands none USB serial decode and
triggering is not supported on
the 3000T X-Series
oscilloscopes.
:SEARch:SERial:USB
Commands
none Searching USB serial decode is
not supported on the
3000T X-Series oscilloscopes.
:TIMebase:REFClock none There is no 10 MHz REF
connector on the
3000T X-Series oscilloscopes.

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English