Siemens SCALANCE XM-400 - No Router-Advertisement-Block

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
103
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
router-advertisement-block
Result
The port discards RAs.
Further notes
Can you allow reception of RAs with the no router-advertisement-block command.
3.1.13.16
no router-advertisement-block
Description
With this command, you allow Router Advertisements (RA) being received at a port.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no router-advertisement-block
Result
The port receives RAs.