Siemens SCALANCE XM-400 - Area Stub

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
529
The parameters have the following meaning:
Parameter
Description
Range of values / note
area-id
Area-ID specify a valid ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
no-summary
NSSA does not receive a summary
LSA.
--
default-
information-
originate
Generating a standard route (LSA type
7) in the NSSA.
--
Result
The area of the type NSSA is configured.
Further notes
You change the type of the area with the no area command.
9.2.3.7
area stub
Description
With this command, you configure areas of the type Stub.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <area-id> stub [ no-summary ]