Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
328 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The interface ID is configured.
Further notes
You delete the interface ID with the no ipv6 interface-identifier command.
You display this setting and other information with the
show running-config command.
7.2.4.10
no ipv6 interface-identifier
Description
With this command, you delete the interface ID.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 interface-identifier <prefix>
The parameter has the following meaning:
Parameter
Description
Range of values / note
prefix
Interface ID
Enter an interface ID.
Result
The interface ID has been deleted.
Further notes
You configure the interface ID with the ipv6 interface-identifier command.
You display this setting and other information with the
show running-config command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English