Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
720 Configuration Manual, 06/2016, C79000-G8976-C252-11
The filter for the value of the metric is deleted.
You create a filter for the value of the metric with the match metric command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
match metric-type
Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the type of the metric.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Call up the command with the following parameters:
match metric-type {inter-area | intra-area | type-1-external | type-2-external }
The parameters have the following meaning:
Routes learnt from different areas
Routes that originate from the same area
Routes whose path costs (metric) are made up from the
external path costs and the patch costs to the ASBR
-
Routes with only external path costs (metric)
The filter for the type of the metric is created.
To Next Page
Loading...
Need help?
General