Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
241
The parameters have the following meaning:
Parameter
Description
Range of values / note
instance-id
Number of the instance or range of
instances whose settings are displayed
• 1 ... 64
• 4094
interface-type
Type or speed of the interface
Enter a valid interface
interface-id
Module no. and port no. of the interface
stats
Shows the number of incoming and
outgoing packets for each path of the
interface
-
hello-time
Shows the intervals at which the root
switch sends its "Hello" message to the
other switches
-
detail
Shows detailed information about the
selected interface
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The port-specific settings are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-tree
command.
6.3.1.10
show spanning-tree passive-listening-compatibility
Description
This command shows whether or not the "Enhanced Passive Listening Compatibility"
function is enabled or disabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English