Siemens SCALANCE XM-400 - Loopd Vlan Mode; No Loopd Vlan Mode

Diagnostics
12.3 Loop detection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
915
12.3.2.3
loopd vlan mode
Description
With this command, you enable the loop detection function for VLAN.
Requirement
● Loopd is activated
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
Syntax
Call the command without parameters:
loopd vlan mode
Result
The loop detection function is enabled for VLAN.
Further notes
You disable the function with the no loopd vlan mode command.
You can display the status of this function and other information with the
show loopd
command
12.3.2.4
no loopd vlan mode
Description
With this command, you disable the loop detection function for VLAN.
Requirement
● Loopd is activated
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
Syntax
Call the command without parameters:
no loopd vlan mode