Siemens SCALANCE XM-400 - No Vrrp Text-Authentication

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
641
9.4.4.11
no vrrp text-authentication
Description
Was this command, you specify that VRRP packets are not authenticated.
Note
This command is available only with layer 3.
Requirement
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> text-authentication
The parameter has the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
Result
The authentication is disabled.
Further notes
You configure a VRRP interface with the interface command.
You enable the authentication with the
vrrp text-authentication command.
You assign IPv4 addresses to a virtual router with the
vrrp associated-ip command.