Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
739
You configure a static address translation with the ip nat static command.
You delete a static address translation with the
no ip nat static command.
You configure a dynamic address translation with the
ip nat pool command.
You delete a dynamic address translation with the
no ip nat pool command.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command you enable NAT/NAPT for the entire device.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
ip nat
NAT/NAPT is enabled globally for the entire device. The device operates as a NAT router.
You disable NAT/NAPT for the entire device with the no ip nat command.
You display the current configuration with the command.
To Next Page
Loading...
Need help?
General