Security and authentication
11.3 MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
831
The MAC access control list is configured.
You exit the MAC ACL configuration mode with the exit command.
You delete the MAC access control list with the
no mac access-list extended command.
You display the configuration of the access control list with the
show access-lists command.
With this command, you configure a MAC address control list that describes the MAC
addresses for which incoming and/or outgoing data traffic is locked.
The access control list contains only one entry. If you want to lock or permit further
addresses, create a new access control list.
Note
Processing order of the lists
The access control lists are processed on
the interface in the order in which they were
The index number of the access control list is not used for this.
You are in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
Call up the command with the following parameters:
deny {any|host<src-mac-address>}{any|host<dest-mac-address>}
The parameters have the following meaning:
Keyword for the MAC address of an
incoming connection that is locked
-
MAC address of the locked incoming
Specify a valid MAC address.
To Next Page
Loading...
Need help?
General