Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
726 Configuration Manual, 06/2016, C79000-G8976-C252-11
match route-type
Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the type of the route.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Call up the command with the following parameters:
match route-type {local | remote }
The parameters have the following meaning:
Directly connected routes (local interfaces)
Learnt or statically configured routes
The filter for the type of the route is created.
You delete the filter for the type of the route with the no match route-type command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
To Next Page
Loading...
Need help?
General