Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.4 IP access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
836 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip access-list standard<access-list-number(1-128)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
standard
Specifies that a standard access con-
trol list is generated
-
access-list-number
Number of the standard access control
list
1 ... 128
Result
The access control list is deleted.
Further notes
You generate an IP access control list with the ip access-list command.
You display the configuration of the access control list with the
show access-lists command.
11.4.3
Commands in the Interface Configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English