EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #558 background imageLoading...
Page #558 background image
Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
558 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.2.4.9
ip ospf hello-interval
Description
With his command, you specify the interval between two Hello packets.
Note
This command is available only with layer 3.
Requirement
The interface is an IPv4 interface.
You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf hello-interval <seconds (1 - 65535)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
seconds
Interval in seconds
0 ... 65535
Result
The interval is specified.
Further notes
You delete the interval with the no ip ospf hello-interval command.
You show the configuration of the OSPF interface with the
show ip ospf interface
command.

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals