Siemens SCALANCE XM-400 - Distribute-List Route-Map

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
681
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
no distance [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
route-map
Keyword for a route map
-
name
Name of the route map Maximum of 20 characters.
Result
The value for the administrative distance is reset.
Further notes
You specify the administrative distance with the distance command.
9.6.3.5
distribute-list route-map
Description
This command enables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
distribute-list route-map <name(20)> {in | out}