Siemens SCALANCE XM-400 - No Dot1 X Guest-Vlan Vlan-ID

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
872 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x guest-vlan vlan-id <vlan-id (1 - 4096)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan-id
Keyword for the VLAN ID
-
- VLAN ID 1 - 4096
Result
The guest VLAN ID is assigned to the port.
Further notes
You reset the guest VLAN ID to the default value with the no dot1x guest-vlan vlan-
id
command.
You display this setting and other information with the show dot1x command.
11.7.3.4
no dot1x guest-vlan vlan-id
Description
With this command, the guest VLAN ID is reset to the default value 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x guest-vlan vlan-id