Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
546 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
no redistribute {static | connected | rip | default | all}
The parameters have the following meaning:
Parameter
Description
static
static routes
connected
connected routes
rip
RIP routes
default
standard routes
all
all routes
Result
Which routes are distributed via OSPF is disabled.
Further notes
You enable the distribution of the routes with the redistribute command.
9.2.3.23
distribute-list route-map
Description
This command enables the filtering of the routing information according to a route map for
incoming routing information.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
distribute-list route-map <name(1-20)> in
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Name of the routing table.
Maximum of 20 characters.
in
Incoming routing information is filtered.
-

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English