Siemens SCALANCE XM-400 - Poe Type

Configuration
3.5 PoE
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
137
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no poe custom maxpwr active
Result
The user-defined maximum power is disabled for the relevant interface.
Further notes
You configure the user-defined maximum power for an interface with the poe custom maxpwr
command.
You enable the use of the user-defined maximum power with the
poe custom maxpwr active
command.
3.5.3.7
poe type
Description
This command specifies a character string that describes a connected device in greater
detail.
Requirement
You are in the Interface configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
poe type <string>
The parameters have the following meaning:
Parameter
Description
Range of values / note
string
Description of a connected device
max. 255 characters