Siemens SCALANCE XM-400 - Redist-Config

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
542 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
no network <network number> area <area-id>
The parameters have the following meaning:
Parameter
Description
Range of values / note
network number
Network number
Enter a valid network number
area-id
Area-ID enter an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
Result
The OSPF interface is removed.
Further notes
You create the OSPF interface and the area with the network area command.
You can display the status of this function and other information with the
show ip ospf
interface
command.
9.2.3.19
redist-config
Description
With this command, you configure the information for the route. The routes are further
distributed with this information.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#