Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
674 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.5.5.15
vrrp track decrement
Description
With this command you assign a VRRP interface to an interface tracking and configure the
value by which the priority is reduced.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> track <group-index> decrement <integer(1-254)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
group-index
ID of the interface tracking
-
integer
Value by which priority of the VRRP inter-
face will be reduced
1 ... 254
Result
A VRRP interface is assigned to interface tracking. The value by which the priority will be
reduced is defined.
Further notes
You delete the configuration with the no vrrp track command.
You display the assignment and value of the priority with the command
show vrrp or show
vrrp interface
with the parameter detail.
You configure the tracking of interfaces with the
track interface command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English